Edit Points

Use the Edit Points tool to fine-tune your tracing by editing individual points. You can do this either while you are tracing, or after all structures have been placed. In addition, only required points are placed when you first trace a ceph. The Edit Points tool provides a way to place additional points.

Use This Feature

• Adjust points while tracing - If you are currently tracing a ceph, hold down the Ctrl key on the left side of your keyboard. Then click and drag individual points as needed to make your tracing as accurate as possible. When you release the Ctrl key, you can continue tracing where you left off.

• Adjust points after tracing is complete - If you have already saved a tracing, enable the Edit Points tool from the Trace section of the main SmartCeph ribbon bar. Then click and drag individual points as needed.

   

  

  ---

• Save your work by selecting Save on the ribbon bar, SmartCeph button, or Quick Access toolbar.

   

  Save from ribbon bar:

  

  Save from SmartCeph button:

  

  Save from Quick Access toolbar:

  

  ---

Notice!

• Zoom Window - You can use the zoom window to place the points most accurately. If you do not see the structures and points in your zoom window, you need to enable the Display Structures feature of your Trace Options. See "Set Up Trace Options" for details.

• Use SmartCeph
  • Open Premier Imaging
  • Trace a Ceph
  • Edit Individual Points
  • Copy or Print an Image
  • Full Screen Toggle
  • Recalibrate Images
  • Overlay Bolton Standard
  • Superimpose Images
  • Visually Enhance Ceph
  • View Analysis
  • View/Print Analysis Report

Open topic with navigation